Lluís trims the APTITLIG bamboo chopping board into an elegant floating nightstand. A minimalist shelf, without legs and barely visible brackets beneath. It is not meant to hold a lot of weight but it’s perfectly functional for your nightcap and next-to-bed essentials. Here’s how:
1. Using a table saw, cut a bevel edge for all 4 sides of the chopping board.
2. Sand the cut edges with an orbital sander and finish with fine grit sandpaper.
3. Next mark where you want the brackets to go.
4. Score the marked lines with a penknife.
5. Use a router to create grooves for the brackets.
6. Apply Cyanoacrylate glue (aka Superglue) to the brackets and press them into the groove. Spray Cyanoacrylate Accelerator to speed up the adhesion.
5. Screw in the brackets.
6. Use one of the bevelled pieces cut from the APTITLIG to cover up the brackets. Cut it into the right length.
7. Attach the cover piece with glue.
8. Let dry and sand down the edges.
9. Wipe down with mineral oil. Finish with blended wax. Wipe off excess.
10. Attach to the wall with screws and wall plugs. Use a leveller to make sure the table goes on level.
~ by Lluís (woodworking barcelona)
The post Bamboo IKEA cutting board into Floating Nightstand appeared first on IKEA Hackers.
Bamboo IKEA cutting board into Floating Nightstand published first on www.ikeahackers.net
No comments:
Post a Comment